Tuesday, January 30, 2007
Sunday, January 28, 2007
Today I finished the hull topside panels, all the 6mm doublers for the tops of the stems, skegs, and rudders, and finally, the beam and shroud lashing cleats (since they come out of the single sheet of 18mm ply the rudders, stems and skegs were cut from and I wanted to reduce the amount of leftover ply I have to store). I then spent the rest of the day laying out the bulkheads, but I'm not quite ready to cut those yet. I'm still contemplating some minor changes in the accomodations and I have to work out the details before cutting bulkheads.
Thursday, January 25, 2007
Laying out and cutting the hullsides is easier if you have a flat workbench at least 24 feet long....
I've been making sawdust again today. The weather was perfect for working outside in an open shed. I layed out the first three sheets of 6mm ply end to end on my workbench and measured and drew out the station lines that determine the hull panel curvature. Bulkhead positions were marked, everything was checked at least twice - both in feet and inches and in millimeters, just to be sure, then the first set of hull panels were cut. Each hull side requires three sheets of 6mm plywood, for a total of 12 sheets in all. This includes the straight one-foot wide sections that the topside panels are made from. After the first three panels were cut, I used them as templates to mark the remaining panels. All these panels will get two coats of epoxy on the inside surface before assembly. Since I'm planning to finish the inside of the boat bright, rather than painted, I'm taking care not to leave station lines and other marks on any panels where they will show, as once they are coated in epoxy they cannot be erased. The bulkhead lines won't matter, as they will be hidden by fillets and the bulkheads themselves.
The forecast is calling for another good day tomorrow, but I won't be boat building, instead I'll be sailing. I have to go to Biloxi early in the morning to estimate a teak deck job on a motoryacht, so while I'm there, of course I'll take Element out for a daysail. The wind is supposed to be 15-20 knots out of the east. Perfect.
Wednesday, January 24, 2007
Tomorrow, I have another free day, so I hope to lay out the panels for the first hullside, cut them out, and use them for templates to mark the other three hullsides.