Work is ongoing on the port and starboard cabin interiors, as both forward decks have now been on for several weeks and the plan is to work my way aft with completing the main interior areas and then making and installing stern decks. The port hull is still a bit ahead of the starboard, as can be seen below. Here the galley sink and shelves have been installed and the outboard cabin side is filleted in place. Only a small amount of cosmetic filleting remains to be done in this area.
Here's a view looking into the port galley hull from the area where the companionway will be. Another small shelf will be added on top of the middle stringer on either side of the sink, to utilize an otherwise wasted space. The companionway steps are also installed but not visible from this angle.
Here's an exterior view of the port hull with the outer cabin side installed.
From this angle you can see the plywood portlight trim rings and how they have been filleted to the cabin side. These will be fiberglassed over right along with the surrounding surfaces. The Lexan will be fitted from the inside with matching trim rings to hold it in place.
Below is a view of the port foredeck just after installation. The temporary screws have been removed and the holes filled with epoxy.
Here's the starboard foredeck after fairing and pre-coating with epoxy. The decks will be fiberglassed next and then the hatch coamings will be built.
Inside the starboard hull I'm working on the layout of the shelves and panel faces that will house the 12-volt switch panels, battery voltage monitoring meter, VHF radio, SSB receiver, stereo and an AC inverter.
Most of these items will be mounted under the shelf in the companionway area of the hull, where you can see the open vertical framing here.
Removable panels of teak-faced 6mm ply will be screwed to the outside of this vertical frame. The instruments will be fitted in the removable panels, and all wiring organized inside under the shelf and accessible by removing the panels. Now that these sheer-level shelves have been fitted in the starboard hull, in the next couple of work sessions I can finish and install the outer cabin side.