Sorry for another long break between posts. I have been working on the boat some during this time, although nothing major. In July, I signed a publishing contract for another book, and this one is due to be completed in just six months. It will be my top priority until then, but there will be time to work on the boat here and there, and the best weather for building here is between now and December.
Most of what I've been doing on the boat is not worth photographing, as it has been the seemingly endless little tasks of filling and fairing, sanding and priming of the foredecks and cabin sides. I put the first coat of paint on the foredecks so I could see the last of the tiny imperfections and fill them. Now, I'm ready to make a trip to the coast this weekend to buy more paint and non-skid additive so I can complete them.
Below is a photo of the port hull with the cabin roof temporarily fitted with screws and the forward deck hatch sitting in it's approximate location. I fitted internal carlins that will support the hatch from below, the outboard one also defining the outboard edge of the companionway opening. Notice too the camber of the coachroof. I like the way this came out, and it will actually make the roof stiffer than it would be if it were flat, as in the plans. The edges are untrimmed here. After installation, they will be cut flush with the router and rounded over like the deck edges.
Here's a view from inside the port companionway, showing the carlin that supports the outer edge of the opening. This will aid in building the hatch coaming as well. Again, you can see the camber in the roof. The companionway opening is 26 inches long by 24 inches wide - small enough to be strong and seaworthy, but large enough for easy entrance and exit.
It will still be awhile before I permanently install the cabin roofs. I want to complete as much as possible in the interior while it is is still open, especially the final sanding and and the installation of the fixed portlights.