Last week I finished rounding up the various parts and pieces that will enable me to finish enclosing the hulls once the cabin roofs are installed. This includes a large hatch over each bunk in the cabin roofs and an opening portlight in each aft cabin bulkhead.
Other deck hardware includes mooring cleats. The two larger ones in the photo below will be the bow mooring cleats. The sterns will be fitted with the same. The smaller cleats will be mounted on the cabin tops, near the outboard sides for use as midships mooring cleats; good for attaching spring lines, fenders, etc. You can never have too many cleats on a boat, and after sailing Abaco to the Bahamas, I like the way David has his cleats located on the decks. In order to mount the two bow cleats, I am having to install a small, 4-inch inspection plate forward of each forward bulkhead, so I can reach in with a wrench and through-bolt the cleats to the deck. Large backing plates will be used on the undersides of the decks.
The big deck hatches that will be fitted over each bunk near the forward ends of the cabins are manufactured by Bomar and the opening size is 16 x 16 inches. This is large enough to get in and out through if necessary, and will let in plenty of air. The hatches can also be locked in the vent position, allowing some air into the cabins, while keeping out the rain when the boat is left unattended.
The opening portlights are the Lewmar Standard series in size 0. Though small, they will help greatly in allowing a cross-flow of fresh air down below, and they come with insect screens for those shallow water anchorages close to the beach. In addition to the two that will go in each aft cabin bulkhead, I'm considering adding one each on the inboard cabin sides forward of the main bulkhead and just above the cockpit seats and jib sheet tracks.
In the photo below, you can see that the outer cabin sides have been primed in preparation for painting and installing the fixed Lexan portlights. The starboard foredeck is a bit ahead of the port one in that it is now primed and most of the little fairing issues have been taken care of. Both foredecks will be painted soon, then the bow access hatches and bow cleats can be mounted permanently.
We finally got a break here just yesterday from a two-week long heat wave in which afternoon temperatures have been at 100-103F every day. After living with that for awhile, today's high of only about 88F felt like a taste of fall!